Breeding skills of rose in January

First, choose a branch that has just finished flowering. Such a branch has full vitality and fast rooting

Cut off the residual flowers on the branches, remove the leaves in the middle of the branches, and peel the branches with a knife, with a length of about 1 cm. Pay attention to clean peeling and completely expose the xylem

(photo Author: former source of happiness; home in Shenzhen)

Then find a flowerpot, fill it with loose and breathable matrix, and mix nutrient soil, vermiculite and perlite. Press the treated branches into the flowerpot. In order to prevent the branches from springing out, press them with stones

Water every day and keep the basin moist. When you see some new branches and leaves growing from the branches, it means that the part pressed in the soil has taken root. At this time, you can cut it off and put it in the basin

(photo Author: former source of happiness; home in Shenzhen)

Using this method to propagate roses, almost 100% survive. Even if they fail, they can come back again and do no harm to roses

Breeding skills of rose in February

The above Flower introduced a very easy-to-use breeding method to you, but some flower friends also found that some rose branches are not easy to bend, and they break when they bend. What should we do? You can also use the following small methods

First of all, as in the above steps, cut off the spent rose flowers, and then cut a space of 1 cm with a knife ring in the middle of the branch, close to the bud point, and remove the epidermis, leaving only the xylem

Tips:

In order to avoid bacterial infection, you'd better disinfect the knife, bake it with fire, or soak it with potassium permanganate alcohol

(photo Author: Qiyun tingxue source: Sina blog)

Apply a little rooting powder on the wound to promote rooting, and then put a plastic bag on the wound

(photo Author: Qiyun tingxue source: Sina blog)

Tie the lower part of the plastic bag with iron wire without being too tight, so as to facilitate the breathing of branches

(photo Author: Qiyun tingxue source: Sina blog)

Fill the plastic bag with wet sand, and then fasten the plastic bag

(photo Author: Qiyun tingxue source: Sina blog)

In this way, the white roots can be seen in the bag for more than a month. Then remove the plastic bag, reduce the rooted branches, select loose and breathable soil and put the branches in the basin

(photo Author: Qiyun tingxue source: Sina blog)

After being put into the pot, it can be placed in a cool and ventilated place for curing for a period of time. After the branches recover their growth, it can be placed in a place with sufficient light for curing

Flower friends, have you learned

If you have any questions, please leave a message to Huahua ~