Water cup

1. Prepare unused cups, nails, hammers, towels and washbasins

(author: seven night elf source: stepping on flowers) 2. Fill the basin with water, put the cup in and soak it for more than 24 hours 3. Soak the towel in water, wring it dry, and then put it into the quilt. You must keep it slowly

(author: seven night elf source: stepping on flowers) 4. Turn the cup upside down, align the nail with the middle part, and knock it down with a hammer (the girl's strength is just good)

(author: seven night elf source: stepping on flowers) 5. Punching is completed! Then just plant flowers and plants

(author: seven night elf source: stepping on flowers)

Wine bottle

1. Prepare cotton thread, wine bottle, alcohol, bucket and cold water 2. Wrap the cotton thread around the wine bottle, and then dip the cotton thread with alcohol 3. Ignite the cotton thread 4. After the cotton thread is burning for ten thousand, put the wine bottle into a bucket full of water

(source: 51 Feibao) 6. Due to thermal expansion and cold contraction, cracks will appear at the winding place of cotton thread. Hold it up and down with water and break it gently to divide it into two parts 7. Polish the broken part with sandpaper. If there is no sandpaper, stick the fracture with adhesive tape to avoid hurting people

(source: 51 Feibao) 8. Plant plants and you're done

(source: 51 Feibao) 9. If drilling is required, please refer to the steps of cup drilling

Plastic bottle & amp; Plastic can

1. Prepare tools, textured tape and plastic bottles & amp; Plastic cans

2. Cut off the top half of the plastic bottle and clean the box of bean paste

3. Wrap the adhesive tape around the bottle ~

Plastic bottle

1. Cut the plastic bottle

2. Cut into small strips as shown in the figure

3. Press it in the opposite direction to make all the thin strips unfold

4. Fold four thin strips in a group. The folding method is shown in the figure

5. Article 2 is the same as Article 1

6. The last part should also be inserted ~

7. Complete

Can & amp; Disposable paper cup

1. Cut the can from the bottom

2. Cut the edge into a long strip as shown in the figure below, and then press it upside down to expand the thin strip

3. Follow the method shown in the figure. The three pieces are folded in a group. When doing this, pay attention to your hands and don't be scratched. At the same time, the third piece should press the first piece up ~

4. The operation of the second group is the same as that of the first group. Pay attention. The third one is ~ that presses the first one

5. Fold the rest in turn

6. Take out the original bottle bottom and roll down the thin strips around it

7. Put the rolled one upside down

8. Just put the two together ~

it's OK to change to a paper cup ~