Geranium branch cutting

Step 1

Collect several disposable plastic water cups and tie 10 small holes in the bottom

Step 2

Use a sharp knife to cut the geranium branches into small segments of about 10cm, keep the upper 1-2 leaves and dry in the shade for 1 day

Step 3

Fill the plastic cup with sand, pour it through, and then insert the geranium branches into the sand

Step 4

After inserting, put the geranium in a place with astigmatism and ventilation, spray water twice a day, and water it once every 2-3 days. After a few weeks, the geranium root system is full and sends out buds, and then it can be desanded and moved into the basin

Camellia branch cutting

Step 1

Cut several semi lignified branches of Camellia with 3-5 leaves, cut off the lower 2 leaves, leave only the upper 3 and dry for 3-5 hours

Step 2

Cutting soil is prepared with 20% coarse sand and 80% perlite. Sand and vermiculite can also be used. Cut off half of each leaf on the branch, insert it into the soil and water it thoroughly

Step 3

Cover the flowerpot with a layer of plastic film, tie a few small holes on the edge and put it in a place with astigmatism and ventilation. Open the film at noon every day and spray water for ventilation

Step 4

About a month or so, you can take root and sprout. After taking root, you can transplant it into the flower pot

Rose branch cutting

Collect the mineral water bottle, tear off the plastic paper on the bottle body, and leave 1-3cm water at the bottom of the mineral water bottle

Step 2

Cut 1-2-year-old rose branches, about 5-8cm long, cut off the flowers and keep all the leaves

Step 3

Put the rose branches into the mineral water bottle and let the ends of the branches touch the water without covering

Step 4

Put the mineral water bottle on Nanyang terrace, South windowsill, east-west balcony and other places with ventilation and scattered light for maintenance. Try to let the leaves come into contact with the sun. Remember not to cover the mouth of the bottle

Step 5

If the water in the water bottle is dry, pour it quickly, not more, and always keep the water level at 1-3cm. If the temperature is higher than 20 ℃, it can take root in 1-2 weeks

Long life cuttings

Step 1

Cut off some strong lignified branches of Changshou flower

Step 2

Cut the branch into several sections with a sharp knife, 2 pairs of leaves in each section, remove the lower leaves and leave only a pair of leaves at the upper end. Dry in a place with astigmatism and ventilation for 3-5 hours

Step 3

Insert the dried branches into the substrate, do not bury the leaves, and pour them thoroughly. The substrate can be garden soil, perlite, river sand and vermiculite

Step 4

The planted longevity flowers shall be maintained in a place with astigmatism and ventilation, dry and wet, and spray water around the leaves twice to four times a day

(Note: the pictures come from the Internet and the copyright belongs to the original author. Due to restrictions, some pictures cannot be found and the author has not been marked. If your rights and interests are infringed, please contact Huahua wechat qdxixi or qq1273160598 for deletion or copyright payment.)