Rieger Begonia

Rieger Begonia likes the warm and humid growth environment, but sometimes it can be found that the flowers are still in bloom, but the leaves are wilting. This is mostly caused by insufficient air humidity or excessive watering

Step 1

Rieger Begonia likes humidity, so when breeding, the probability of leaf decay is very high

If the situation is not very serious, the leaves can be directly removed and sprayed with carbendazim or streptomycin for anti-corrosion

Step 2

If the rot is serious, you can cut the Rieger Begonia into baldness and keep the healthy part. Pay attention to keep a few leaves. Generally, it can germinate again after 20 days

Step 3

In addition, another method is to re cut, select healthy branches and insert them into the soil. Pay attention to keep them moist. Generally, they can take root in 10 days

Step 4

Rieger Begonia can be watered with rice vinegar or ferrous acid solution. If it is tap water, it should be put for another day when watering the flowers

Ping An tree

During the cultivation of Ping An tree, its leaves will turn yellow and fall off due to poor ventilation, excessive watering, lack of iron and other reasons. However, as long as the right medicine is applied to the case, it will be saved

Step 1

Ping An trees are watered too much, and new leaves, tender yellow and fallen leaves will appear at that time. At this time, you need to put the Ping An tree in a cool and ventilated place, and then insert several holes in the soil to let the water evaporate

Step 2

There is also a case of iron deficiency leaf loss. At this time, ferrous sulfate can be directly diluted and irrigated

Step 3

Excessive fertilization will also lead to leaf loss of Ping An trees. At this time, we need to quickly change the basin, take out the plants from the basin, clean up the rotten roots, and then replant them

Step 4

There is also the possibility of beheading. Cut off all the leaves of Ping An tree and leave only the branches and stems to germinate again

Crab claw orchid

In the process of breeding, crab claw orchid is prone to rotten roots, wilting and soft stems. Although it is very serious, it can still be rescued

Rescue measures

1. Cut down the branches for cutting, and cut them directly with a small knife. Note that they should be annual strong branches with nodes

2. Prepare the soil, mix pine needle soil, perlite, vermiculite, etc., and spray with water

3. The rooting place of the branches to be cutted can be smeared with rooting powder to promote rooting~

4. Insert the prepared branches into the soil and be careful not to break the skin of the crab claw ~ pay attention to keep a good distance when cutting the branches~

Camellia

In fact, camellia is also very hot. If it is not maintained properly, it is prone to rotten roots, yellowing and falling off of leaves, and even may not bloom

Branch cutting

1. Camellia can be saved by cutting. The cutting soil is preferably loose and breathable acidic soil, which can be made of 80% perlite + 20% coarse sand or pure vermiculite

2. For cuttings, you can choose the semi lignified branches of the current year. Remove the leaves at the lower end and only keep the top two leaves and one bud healthy. The branches need to be soaked in carbendazim for a while and then used after drying

3. Insert the base of the branch into the soil, spray the soil wet, cover it with plastic bags or glass, and pay attention to moisture retention and ventilation< span>