Homemade Swan flowerpot

Manufacturing steps:

1. Prepare a relatively large plastic bottle, cut off one side after lying flat, then fill it with soil, finally bend a thick iron wire, bend the iron wire into S shape, and insert one end into the mouth of the plastic bottle

2. The outside of the plastic bottle shall be coated with cement, and the contact between the bottle mouth and the iron wire shall also be coated with cement. (in order to create the appearance of white swan, cement and gypsum can be mixed to make white cement)

3. Find two barbed wire nets longer than the plastic bottle and stick them close along the outside of the plastic bottle as the two wings of the swan

4. Then completely cover the wire mesh with cement

5. The part of the thick iron wire can be wound with gauze or white cloth one by one, and finally cement is smeared on the cloth

6. In this way, a swan flowerpot can be made in a few minutes. Don't forget to punch kong'ao at the bottom, otherwise the flowerpot will be impermeable

7. Finally, don't forget to draw the eyes and mouth of the swan, and then plant flowers directly in the Swan pot

Homemade irregular flowerpot

Manufacturing steps:

1. Prepare the required materials: an irregularly shaped fruit tray, a plastic cup and mixed cement. First clean the inside of the irregular plate, and then apply a layer of glue on the inner wall of the plate

2. Put a layer of glue around the outer wall of the prepared plastic cup

3. Place the mixed cement in an irregular basin until the whole basin is filled

4. Press down the plastic cup in the middle of the basin filled with cement, not to the bottom, so that the upper part of the plastic bottle is slightly higher than the cement surface, and then turn the basin around and tie several small holes at the bottom to achieve the purpose of water and air permeability

5. Then put it in the sun. When the cement is completely dry, take down the plastic bottle and the outer basin, and a beautiful irregular cement flowerpot will be done

6. Flower friends can also make flower pots of any shape they want according to this method. Raising flowers is very beautiful

Homemade cake flowerpot

Manufacturing steps:

1. Prepare a paper box, cut it into the shape as shown along the edge and corner line of the paper box, then prop it up and stick a folded corner with tape

2. Fold the paper box into a three-dimensional triangular prism, and then slowly pour the mixed cement into the carton

3. Find a plastic bowl smaller than the paper box and press it down in the center of the box filled with cement. Then use chopsticks and other things to poke a few small holes at the bottom and use them as drainage holes

4. Then it is exposed to the sun for a period of time to allow the cement to set fully. When the cement is completely dry, you can take out the plastic bowl and paper box, so that a small cake flowerpot is ready

5. If you think the flowerpot made in this way is not beautiful, you can also apply your favorite color on the finished flowerpot

Homemade leaf flowerpot

Operation steps:

1. To make a leaf pot, you need to prepare materials: cement, large leaves, dyes and soil

2. Spread out the soil layer, then lay the leaves on the soil, press it slightly, and try to make there is no gap between the leaves and the soil

3. Pour the mixed cement on the leaves until the whole leaves are covered, and then put a few small holes in the bottom to make it permeable and breathable

4. When the cement is completely dry, remove the leaves from the flowerpot

5. If you think the color of cement is ugly, you can dye it into any shape you like

In addition to the cement flowerpots introduced above, there are many beautiful flowerpots that can be made with the simplest cement