1、 Cutting method

1. Time selection:

It's best after flowering, or from May to June

2. Matrix selection:

Considering the drainage performance, nutrient content, air permeability and many other factors, we can choose river sand or vermiculite

3. Specific steps:

After flowering, while cutting off the inflorescence, we can cut off the flower branches with tips by the way. Note that the cut flower branches should not be too long, five to ten centimeters. After cutting off, we have to cut off the leaves in the lower half, and only half of the leaves in the upper half can be left. Then, insert them into our prepared matrix. Ensure the temperature, humidity, ventilation and other conditions, and it can be observed that it takes root in about a month. When their leaves grow out, they can be transplanted

4. Precautions:

When selecting the insert, you can also select three or four sections of the segment. Also, if cutting is carried out in spring, we can put it together with the pot change

2、 Combined cultivation method

1. Select material:

In order to improve the survival rate, we have to choose those strong branches without diseases and pests

2. Specific methods:

First, hydroponics. Then, when the new branches grow, we will take them out and soak them in alcohol for about half a minute for disinfection and sterilization. Next, cut off the base of the stem with sterilized scissors and put it on the culture medium for culture. After culturing for a period of time, remove it for disinfection and plant it in the substrate. Make sure the surrounding humidity is sufficient and be careful not to shine in the sun. By doing so, we can control the success rate at about 90%