Cut one knife after longevity flower and burst again in a month

Many Huayou's family's longevity has basically failed. At this time, as long as you learn to cut a knife with Huahua, you can sprout new buds immediately and burst the pot again soon

How to prune the long life of failure

1. Usually, if you find that the color of longevity flowers at home begins to turn black, and the flowers feel a little soft, and the flower stems begin to droop, you basically need to trim them

2. When pruning, use sterilized scissors to cut from the position of 2 pairs of leaves under the flower. As shown in the following figure, trim from the position below 2

3. After pruning the longevity flower, put it in a cool and ventilated place to dry the wound. After about 1 week, transfer it to nanyangtai to receive sufficient sunshine. During this period, it was found that the surface of the basin soil turned white and then watered to avoid rotten roots

4. If you want the longevity flower to sprout new branches as soon as possible, you must supplement nitrogen-containing fertilizer in time. You can bury 3-5 grains of compound fertilizer in the flower pot, or use self-made rotten soybean fertilizer and soybean residue fertilizer to make the longevity flower grow new branches and bloom more

5. Don't throw away the pruned branches, because the nutrients of the branches after flowering are particularly sufficient. If they are used for cutting, the rooting rate is very fast. They can be cut and rooted in about 20 days

Cut 1 knife after the crab claw orchid. Open it several times if you want

Some flower friends' crab claw orchids only open once and don't open anymore, but others' crab claw orchids can open 3-4 times a year. What's the matter? Of course, the post flower pruning is in place

How to prune the failed crab claw

1. If you find that the flowers of your crab claw orchid have begun to wilt in varying degrees, take a pair of scissors and trim them, otherwise the flowers will stay on the leaves and consume unnecessary nutrients

2. When pruning the remnant flowers with scissors, cut off the middle section of the 2nd-3rd leaves under the remnant flowers, that is, cut off the 2 leaves from the remnant flowers. If the leaves of the remnant flowers are long enough, you can also cut more. Basically, only 6-8 leaves per branch are enough

3. After pruning the residual flowers, the branches shall be cut short, and some old stems and too dense stem nodes on the branches shall be cut off. After pruning, the new branches will be more green and strong, so as to make the flowering more lush

4. After flowering, the crab claw orchid consumes a lot of nutrients, so there is a short dormancy period. At this time, we can take advantage of the dormancy period to change the pot for the crab claw orchid, cut off the old roots and weak roots, and then put enough base fertilizer on the bottom of the pot, such as bean cake fertilizer, bone meal fertilizer or bean residue fertilizer retted by ourselves

5. During the dormancy period, control the water and stop fertilization. After new buds appear on the stem nodes, apply thin liquid fertilizer once every half a month. Do not contaminate the stem nodes during fertilization, so as to make the abnormal stems grow rapidly. Spray 0.2% potassium dihydrogen phosphate solution after budding, and the crab claw will bloom again soon

6. Don't throw away the pruned crab claw leaves. Prepare peat soil and perlite 2:1 nutrient soil. Cut the crab claw leaves and they will take root in about 10-20 days

Cut 1 knife after the camellia flower. Open it several times if you want

Because of different varieties, some Camellias in Huayou's house are still in bloom, and some Camellias in Huayou's house have basically failed to bloom and are ready to enter the growth period of spring shoots. At this time, we have to trim them quickly

How to trim the failed Camellia

1. After the camellia blossom at home, it must be trimmed in time to avoid unnecessary nutrient consumption. After the camellia blooms, the pedicel will be left on the branches. The post flower pruning we need is mainly to prune the two leaves at the top under the pedicel

2. Cut off the two leaves at the top of the pedicel. If the top leaves are staggered, just trim one. Because the growth of Camellia has the advantage of top, the new shoots are pulled out from the top, so after pruning, it can promote the lateral branches of camellia to grow, make more and more branches, and then bloom more and more

3. After pruning the remaining flowers, retract and trim the branches, and cut off the old branches, weak branches and parallel branches, so as to promote the development of new branches and improve the vitality of Camellia

4. After the residual flowers of Camellia are trimmed and before the spring shoots sprout, a compound fertilizer based on nitrogen fertilizer or soybean residue fertilizer can be applied once to supplement enough nutrients to make the camellia sprout. After the new buds sprout, a leaf fertilizer can be sprayed once to make the spring buds sprout and have vitality

5. When the spring tip of Camellia grows to 10-20cm, wipe the bud on the spring tip, remove the bud point at the top, leave 3-4 leaves, and let the lateral branches pull out as soon as possible, so as to make the whole plant type of Camellia look better

6. Don't lose the cut Camellia branches. If you trim them a little, you can cut them directly into the soil. When the temperature is high in spring and the temperature and humidity are enough, the cutted Camellia can take root in about 10 days

Cut a knife after the Cyclamen comes to spend, and open two crops of flowers immediately

Many Cyclamen in Huayou's family died directly after the Spring Festival, and then they were directly thrown into the trash can. In fact, after the Cyclamen comes to blossom, as long as it is well maintained, the compound flower is super simple

How to trim the failed Cyclamen

1. When Cyclamen comes to flower, it is necessary to cut off the remaining flowers in time. Generally, it starts from the bottom of the flower root and cuts off the whole flower stem

2. In addition to the remaining flowers, those withered branches and leaves should also be removed. If you don't want to use scissors, you can pull them down directly

3. Cyclamen flower consumes a lot of nutrients in the seed ball. Therefore, after pruning, nutrients must be supplemented. You can bury 2-4 grains of compound fertilizer in the flower pot or pour some self-made liquid fertilizer to make the seed ball accumulate nutrients

4. The summer weather is hot, cyclamen will enter the dormancy period, and the leaves will wither continuously. At this time, stop water and fertilizer, and put the flowerpot in a cool and ventilated place indoors for maintenance, so that it can spend the summer safely

5. When the temperature drops in autumn, cyclamen seed ball will wake up from dormancy and begin to sprout new buds and grow flower buds, so as to succeed in compound flower. It's just that the number of Cyclamen flowers will be a little less than the first time

Cut a knife after the rose flower, and it blooms from spring to autumn

Although many roses in Huayou's family are still growing buds, some Huayou told Huahua that many first roses are almost finished in the South with high temperature, which makes Huahua envy, envy and hate

How to trim the failed roses

1. After the spring flower of rose is over, the failed spring flower must be cut off in time, so as to avoid nutrient consumption, so as to make the rose have enough nutrients for the second flowering immediately

2. When pruning, tilt 45 ° from the top of the three leaves of the rose, about 0.5cm, and trim obliquely inward, so as to cut off the remaining flowers

3. The blind branches and weak branches on the rose branches should also be cut off in time, and the bud points and leaves growing inward and downward should also be cut off at the same time, so as to promote the ventilation and light inside the plant, enhance the disease resistance of the rose, and provide more nutrients to the flowering branches of the rose

4. After the rose blooms, if you want it to sprout as soon as possible for the second flowering, you must supplement fertilizer in time. For example, rotten rice washing water and compound fertilizer can be used for the rose, about once every 10 days. After the rose sprouts, you can also pour some fishy water, which can make the rose bloom big and much

5. The pruned rose branches are cut into small segments of about 7-10CM, which can be directly inserted into the soil for cutting, or put in the water for cutting, and basically take root soon

About post flower pruning

That's all for Huahua today

You flower friends also want to know what kind of flower pruning

Why don't you leave a message to Huahua below