Cotton strip water absorption method

This can be said to be very simple. You can see it with a picture. One end of the cotton strip is soaked in water, and the other end is tied to flowers, which can complete the task of automatic watering

Note: meat is very drought resistant. You don't need to water at all during the 7-day holiday. You can try this method for wet plants such as green pineapple, white palm, and other drought resistant grass and flowers

Plastic bag seepage method

Find a watertight plastic bag, fill it with 8 minutes of water, tie the mouth tightly, poke a small hole at the bottom with a needle or toothpick, and then put it in the flower pot

Green pineapple, asparagus, green bean petals, ivy, Pennisetum and other wet loving plants are applicable

Infusion tube drip method

The infusion tube and beverage bottle can be made into an automatic drip irrigation device to complete automatic watering by hitting the hanging bottle

Operation method

1. Find a plastic bottle and use a heated screwdriver to drill a small hole of about 5mm under it

2. Insert the needle of the infusion tube and stick the interface with watering to prevent water leakage

3. Insert the other end of the infusion tube into the soil, and the flow rate can be adjusted by yourself

Note: remove the bottle cap during infusion. If it is an upside down plastic bottle, tie a small hole at the bottom of the bottle to breathe and increase the air pressure, otherwise half of the drop will not produce water

You can also directly use a water basin instead of a plastic bottle, which is simple and convenient, as shown in the following figure ↓↓

Plastic bottle replenishment method

A plastic bottle and a tray can be used as an automatic watering device. When there is less water in the tray, it will automatically absorb water; When the tray is full, stop absorbing water

Operation method

1. At the 1 / 5 position below the plastic bottle, scald two holes with a small screwdriver at a distance of 1cm as the inlet pipe and outlet pipe respectively

2. Find two straws as the outlet pipe and inlet pipe, put the flowerpot in the tray containing water, completely insert the outlet pipe into the water, and the inlet pipe is just on the water surface. As shown in the figure ↓↓

3. Give the plastic bottle an appropriate amount of water, tighten the bottle cap, and an automatic watering device is completed

Super simple basin sitting method

There is one truth between sitting basin and soaking basin. Just put the flowerpot in the container containing water. It is very simple, but pay attention that the water level cannot be higher than the flowerpot

Beer bottle inverted insertion method

Poke a hole in the beer bottle cap. After the bottle is filled with water, tighten the bottle cap and insert it upside down in the basin soil, so that it can be watered automatically