1、 Grafting method

1. Sawing rootstock: the position of grafted branches should be one meter high. Select a tree with only 2-3 branches. Which branch is ready to be used can be sawed off from its 15-20cm place, and other thinner branches can be cut off. The wound should be relatively flat, and the incision should be slightly inclined

2. Cutting anvil: in the place where the skin of the tree is relatively smooth, use a knife to cut a small mouth with an inclination. Don't cut it too deep. Just go to the place where the bark contacts the wood inside

3. Scion cutting: cut an inclined angle of 45 º with a knife under the selected scion. The inclined plane should be 1.5cm long. Leave two small eyes on the other side of the scion, and the excess part can be cut off

4. Binding: connect the scion with the interface, and then bind it firmly with prepared tools, which can not only make it strong, but also speed up the recovery of the wound and increase the success rate of grafting

2、 Precautions

1. Scissors and saws are sharp. Pay attention to safety during operation and do not damage yourself

2. The cut made by scissors and the cut made by saw should be relatively flat, not irregular, and the incision must be inclined