Creative birdcage

Flower collection

Sure enough, it is raising flowers to produce talents,
This is the most creative flower raising method Huahua has seen recently!
It solves the problem that breeding climbing plants cannot build shelves!
By the way, the method of making flowers is also introduced!
Manufacturing method:

1. Preparation tools: wire, iron bar, thick iron wire, thin iron wire and pliers

2. Using pliers, cut two wires of the same length.

3. Try to make the wire into a circle, and both wires should be made into a circle

4. Insert an iron bar into the soil.
5. Put the circle made of iron wire, one on the bottom and the other on the top with thin iron wire. You can refer to the figure below. The red part in the middle can be fixed on the top of the iron bar with iron wire.
6. Wrap it with thin thread~

Creative flower rack

Flower collection

Just say you don't accept this pyramid shaped device?
Anyway, Huahua is in uniform,
Although the home is too small to accommodate the big,
But the small flower has begun to think about it!
Friendly gift making method~
Manufacturing method:

1. Prepare tools: nails, boards, saws2. Order a square base first.

3. Prepare four boards of the same length and a thick stick. Put the thicker stick in the middle of the base, and then put it on the four corners and the stick

4. Then prepare shorter boards in proportion, according to the proportion between the two boards

5. As shown in the figure below, nail the boards one by one

6. Fill in the earth and you're done!
PS：
If there are still remaining boards, in fact, new DIY can also be carried out. In fact, it can also be made into the following figure. See the following figure for the specific method~

Creative PVC pipe

Flower collection
Manufacturing method I:
1. Preparation materials: PVC pipe, electric drill and saw.

2. Several round holes are separated on the PVC pipe

3. Stand the PVC pipe in the flowerpot, fill it with soil and plant flowers~

4. When watering, you can water from the top or from the side. Moreover, the pipe is erected, which can save a lot of space on the balcony!
Fabrication method 2:
1. Preparation tools: PVC pipe, PVC pipe joint and iron wire.

2. Cut the PVC pipe in half and the joint in half. Remember to cut it vertically, not horizontally. Pay attention to safety

3. Plug the side and fill it with soil. The remaining steps are the same.

4. Use iron wire to wrap it around both ends of PVC pipe and hang it directly, so as to avoid punching on PVC pipe

PS：
This can be done not only for PVC pipes, but also for other materials. As long as you can cut them, they can be used. For example, the iron pipe in the figure below.

Plastic bucket

Flower collection

Are there some big buckets at home?
Like a bucket of mineral water bottle or something,
It's a pity to throw it away,
But if you don't throw it away, it takes up some space at home,
In fact, you can make it into a flower raising artifact~
And you can pick as you eat~
The following is the production method of Huahua friendship bonus~
Manufacturing method:
1. Preparation tools: bucket, saw and lighter
2. Find the right direction and cut it with a saw. Because there is no big barrel, Huahua can only be replaced by PVC pipe. In fact, the principle is the same.

3. Then use fire to bake at the sawn place, and then press it down with something hard. If the material of the barrel is relatively soft, you can press it down without fire

3. After finishing the hole, you can fill it with earth, and then you can plant flowers and vegetables!