White palm

Cause of death: too much watering

Many people think that white palm likes water, so they have to pour water on it, resulting in ponding in the basin. The excess water accumulates in the connecting part of the rhizome, which can easily lead to rotten roots and heart

What about too much watering and rotten roots

1. Pour the white palm out of the basin soil, shake off the soil block, and clean the root system with water

2. Check the root system of white palm and cut off the rotten root system of white palm with sharp scissors or blades

3. Apply carbendazim to the wound of white palm for disinfection, and then put it in a cool and ventilated place to dry

4. Plant the white palm into the soil again, water it once, and put it in a cool and ventilated place slowly. Don't expose it to the sun

How to water white palm correctly

Watering follows the principle of no drying and no watering. Stick your fingers into the soil surface for about 3cm. If it is dry, pour it through

Generally, water can be poured once in 7-10 days. In fact, it is not easy to raise the white palm in soil culture. It is suggested that flower friends with poor soil culture should change the white palm to hydroponic culture

Common cause of death of white palm: too much light

Palmetto likes to scatter light. You must not expose yourself to the sun, otherwise it is easy to wilt and droop leaves

How does white palm bask in the sun

Palmetto is best placed in the living room with bright light, or the Nanyang terrace and east-west balcony that are not specially exposed to the sun

What if the white palm is wilted by the sun

1. Don't throw away the withered palms in the sun. First move to a cool and ventilated place

2. Cut off the seriously wilted, withered and yellow branches and leaves to avoid excessive consumption of nutrients

3. If the surface soil is dry, pour water once and spray water to the leaves 2-3 times at the same time; If the surface of the basin soil is not dry, do not water it. You need to spray water on the blades

Geranium

Cause of death of Geranium: black rot in summer

Geranium is prone to black rot, especially in summer, especially in the south. It not only rains a lot, but also is hot

Damp and hot, once the sun is exposed to the rain or the temperature rises, black rot is inevitable

The solution of Geranium black rot

After the black rot of geranium, it is difficult to solve it. The only way is branch cutting! The specific operation steps are as follows:

Cut off the healthy branches of geranium with a sharp knife, remove the bottom leaves, put them in a cool and ventilated environment, and dry the wound for about 2 hours

2. Put the dried Geranium branches in a disposable plastic cup. Add about 1cm of water in the cup, not too much

3. Add water when the water level is low, and change the water every three days or so. It took about 15 days to take root

4. Plant the rooted Geranium into the soil

Methods of preventing black rot of Geranium

1. Water less in summer. When the basin is very light, pour it again. Pour it once in 7-10 days. Moreover, the basin immersion method is adopted for watering, so that the water does not exceed 1 / 3 of the bottom of the basin and can be taken out after soaking for about 3 minutes

2. In summer, do not let the stems and leaves of Geranium get wet, otherwise it is easy to black rot

Copper coin grass

Cause of death of Pennisetum: dry death due to lack of water

Pennisetum is an aquatic flower. Once it is short of water for a long time, it will soon wilt and wither. Therefore, it is generally recommended to cultivate in water or half soil and half water

Treatment method of copper coin grass after water shortage

If your copper coin grass is short of water and its stolons are dry and rotten, there is no way to save it. If only the leaves fall down, watering in time can quickly slow it down. If it dries up in a large area, it can be saved as long as the stolons in the water or soil are green

1. Cut off all the withered, yellow and fallen leaves of Pennisetum

2. Dig out the stolon of Pennisetum from the soil. If it is green, put it in a hydroponic flask with the soil

3. Pour water into the hydroponic flask. The water level is about 1 cm below the soil

4. Put the watered hydroponics bottle in a place with astigmatism and ventilation, and wait for new Pennisetum to grow on the stolon

Correct watering method of Pennisetum

There is no shortage of water for one reason, that is, there is always water on the soil surface. It is best to have soil at the bottom and water above. In summer, pure soil culture is too tired to water all day

Common cause of death of Pennisetum: lack of light

Copper coin grass likes the flood and the sun, and many people put it on their desks. As a result, it died in two days

How does Pennisetum bask in the sun

Put the copper coin grass in the place where the light is better, it will grow better. It is best outdoors, and it can be placed in nanyangtai indoors

Actually

No one would make a flower killer

As long as you carefully sum up experience in setbacks, you will also raise the flowers well