Cutting takes 5 steps and takes root in 1 month

The rose is generally propagated by cutting, and it is most suitable to propagate in May or October:

1. Select a twig about 13cm as cutting, and keep 3 ~ 4 leaflets at the top

2. Cut the upper end flat with scissors, and the lower cut is inclined downward

3. It is best to use shallow basin cutting, and the soil can be humus mixed with sediment to keep it moist

4. Before cutting, disinfect with 0.5% potassium permanganate solution and rinse with clean water. The cutting depth is about 5cm

5. After successful cutting, it usually takes about 20 days to take root. At this time, it needs to be potted

Take the rose out of the original pot and shake it slightly to stretch its roots

Then prepare a slightly larger basin, and then add the loose humus prepared in advance to 2 / 3

Add roses, continue to add soil until slightly full, and pour water once after 3 hours

In this way, the flowers grow bigger and bigger

Soil

Rose is drought resistant and has low requirements for soil. Generally, it can be fattened by adding some leaves and grass roots to the soft and fertile sandy soil. The bottom layer is paved with gravel to increase air permeability and drainage

Watering

Rose likes a slightly wet environment and avoid waterlogging roots. It can be watered once every 15 days in spring and autumn and once every 10 days in summer. At ordinary times, check the dry and wet conditions of the soil. In the slightly wet state, there is no need to water, and then water it after it is dry

Illumination

Roses like light and warmth. They are generally placed on the Nanyang terrace or south window. If possible, they can be placed outdoors to ensure sufficient light. Otherwise, they will bloom less and have weak branches. However, in hot summer, they should be properly shaded to avoid direct sunlight

Fertilization

Roses prefer fertilizer. During the growth period, liquid nitrogen fertilizer can be applied once or twice a month, such as rotten peel water and compound fertilizer, so as to promote the growth of branches and leaves

During the flowering period in April and may, phosphorus and potassium fertilizer can be applied two or three times a month, such as potassium dihydrogen phosphate or rotten banana water and fish intestines water, so as to promote civilization

Pruning

Pruning is an essential part of the maintenance process. Generally, it is repaired once before the long bud. The trunk is left long, the side branches are left with 3 ~ 5 buds, and the rest dead branches and weak branches are cut off. The overall density should be moderate

Pest control

If you don't pay attention to ventilation, light transmission, moisture and exhaust during maintenance, roses are easy to be infected with powdery mildew, black spot, white powder, dark spots and even withered and yellow

found that when infected with pests and diseases, we should immediately cut off the weak branches of the disease branches and spray the three azolone spray with 800 times liquid once a week for 3-4 consecutive times. p>

One more step before flowering, the walls burst open

Roses mostly bloom from May to September, mostly pink and white. Yingying climbs and hangs on the fence or wall, adding a little elegance and romance to the summer courtyard for no reason

So, the question is, how to pull the rose to climb the wall

1. Select a ventilated and transparent wall, cut off all flowering branches and top branches, keep 2 ~ 3 bud points, and manually pull the main branches to the horizontal direction of the wall

2. Pull several iron wires or vines on the wall to fix the rose trunk, arrange the position of other branches according to the extension direction and trim them reasonably. Of course, you can also fix the rose branches directly on the fence

Flower friends, have you learned all these tips

If you also raise a yard of beautiful roses

Leave a message below to share with you