Cut the longevity flower, feed some medicine, and fill the pot with flower buds

"Cut a knife"

1. Cut a knife before flower

If longevity flowers want to bloom more, they must top more in the early stage of growth, cut off the terminal buds and promote the growth of branches. The more branches, the more flowers in the later stage

Technique: when the seedling plant is 10cm high, keep 3 ~ 5 pairs of leaves and 5cm high stems, and then knock off the terminal buds

This topping is accompanied by the whole growth process, and the long-lived flowers will be cut more and more vigorously until the bud comes out

2. Cut a knife after flower

After the flowers wither, quickly cut off the flowering branches and the second pair of leaves below. After a period of time, new buds may bloom again

For the old pile, you can re cut it after the flower withers. If you don't cut it off, the opening will be very poor

Note: when cutting, be sure to pay attention to the position of the lower cutting on the axillary bud, so as to branch well; Keep several large flowers and leaves to promote photosynthesis

"Give me some medicine"

Flowering consumes a lot of nutrients, and the plant is "weak" after flowering. When the flowering branches are cut, it is necessary to quickly supplement some granular fertilizer, and bury several slow-release fertilizers along the edge of the basin to supplement the fertility, so as to have the strength to open the second crop of flowers.  

Crab claw orchid cut a knife, feed some medicine, bloom one after another

"Cut a knife"

1. Pre flower scissors 1 knife

During the pregnancy and bud stage of crab claw orchid, many tender leaves will grow at the top of the branches. This tender leaf can't bloom. It will only consume nutrients. If you remove it, the flowers will be better

Note: if there are less than 4 leaves on a branch, do not remove the young leaves at the top

2. Shave your head after flowers

When the flowers droop and the branches feel a little soft, it means that they are about to fail. At this time, cut off the flower branches and keep only 3 ~ 4 leaves for each branch, so that you can "recharge your energy" in time and prepare for the next flowering

"Give me some medicine"

1. After pruning, bury a circle of compound fertilizer at the edge of the flowerpot and water it after burying it to make it strong as soon as possible

2. After a month, spray some potassium dihydrogen phosphate solution on the leaf surface and bask in the sun at the same time. Soon, the second bud will come out