1、 Water inserting method of rose

1. Cuttings: cut branches of about 10 cm. The upper part shall be provided with leaves, and the lower part shall be inserted into two-thirds of the sponge block. Then put the branches together with the sponge into the bottle and add water at the bottom. The water cannot reach more than two-thirds of the sponge, otherwise it will hinder the breathing and rooting of the branches

2. Light: put the bottle in the sunny place to ensure that the leaves can be exposed to the sun. If the sun is too poisonous in summer, the bottom of the bottle can be properly shaded. At the same time, pay attention not to seal the mouth of the bottle and ensure its ventilation

3. Transplanting: after the Rose takes root, it can be moved into the pot soil. Use garden soil and plant ash as culture soil, and add a small amount of rotten fertilizer as base fertilizer. After pouring enough water, cultivate carefully

2、 Soil cutting method of rose

1. Cuttings: cut branches of about 10 cm. Keep three branches and a pair of leaves at the upper end, remove all the rest, and cut the lower part obliquely at the branches. Then soak the branches in carbendazim solution for 3 minutes, take them out and dry them for standby

2. Basin soil: prepare the soil mixed with perlite and coconut bran as nutrient soil, dip the bottom of branches into the soil with rooting water. Chopsticks can be used to insert holes first to avoid damage to the lower part of the branch

3. Fertilization: spray bactericide every four days to avoid various diseases caused by bacteria. Apply foliar fertilizer every three days to promote rooting. However, the amount of fertilizer should not be too much to avoid burning the branches

4. Bagging: bagging the upper part of branches and leaves can effectively moisturize. But at night, take down the bag for ventilation