1、 Preparation of matrix
Cutting Prunus deltoides needs a highly loose substrate, which is more convenient for it to take root. Specifically, a portion of vermiculite, a portion of perlite and a portion of peat soil can be prepared and fully mixed as the matrix for cutting. If you want it to take root faster, you can also mix some small pieces of slag into the matrix p>
2、 Cutting cuttings
Cut some normally growing sunny branches that have begun to Lignify from the healthy mother plant, and cut them to a length of 7-10CM. Then use a knife to obliquely cut its bottom end, and keep the section of its bottom end at an angle of 45 ° with the branches. Then remove the leaves below it, leaving only 2-3 leaves at the top. After that, soak its bottom with rooting blisters p>
3、 Cutting
Put the prepared flower soil into the seedling container, and then insert the cuttings into it. The insertion depth should be controlled at about 4-5cm. Then, pour some clean water into the soil, wet the flower soil, and then move it to a position with scattered sunlight for a short time, and maintain a temperature of about 20 ℃. After a period of time, it can take root and survive p>