1、 Select blade

Before leaf transplanting, it is necessary to dig out the jade dew from the pot soil and be careful not to damage its root system. Use the sterilized knife to cut from the junction of leaves and rhizomes, and cut as much rhizome tissue as possible. The leaves used for leaf insertion must be complete and in good growth condition

2、 Drying leaves

After the blade is cut off, it needs to be placed in a cool and ventilated place. The blade can be inserted only after the cut part is dried. If possible, apply an appropriate amount of carbendazim to it. Observe the leaves in time during drying, which can be done in almost two or three days

3、 Preparation of matrix

The substrate for leaf cutting shall be prepared in advance, and the soil used shall have good air permeability and be kept clean enough. Some bacteria in the old leaves will not need to be disinfected before using the soil, so it is not conducive to the rooting of the old leaves and insects

4、 Carry out blade insertion

After preparing the substrate, the leaves need to be placed. You can use a little soil to bury its growth point, or insert it slowly into the soil. Then it needs to be watered. It should be kept moist. The leaves must not be soaked in water. Finally, put the cuttings in a ventilated place and wait for it to take root