1、 Watering after Basin

Don't worry about watering begonias after they are in the basin. You can wait about 2-3 hours before watering them. Because it is very likely to hurt the root when putting it into the basin. If the root is hurt, water it at that time, and the root is very easy to rot. Moreover, if it was watered at that time, the root position could not be absorbed normally and would not have an effect

2、 What about watering too much

1. Remove ponding: when too much water is found, remove the ponding at the first time. Then put the plant in a well ventilated place, or raise the flowerpot to separate the middle of the flowerpot, which can speed up the evaporation of water. In addition, it is necessary to control the amount of water. After waiting for a few days, the plant can usually return to its normal growth state

2. Soil replacement: first take out the Begonia from the original basin, clean up the soil at the root position, and observe which are rotten roots. After the rotten roots are found, they should be completely removed, then soaked in the disinfection solution and taken out in a few minutes. Take it out and dry it. At the same time, replace the old soil with new soil and cultivate it

3. Re cutting: if the plant dies due to too much watering, you can cut a section of branches from it for cutting