1、 Cutting time

Its cutting can be carried out except in summer. Summer is its dormant stage, so it should be avoided. It is most suitable around April in spring. Because this is the peak growth season, the plant has strong germination ability, can improve the survival rate, and the rooting speed will be faster

2、 Select Insert

When cutting upside down golden bell, the branches born in the same year and free of diseases and pests should be selected as cuttings, and it is best to have tender tips on them. Just keep the length at 6-10cm. Cut off the leaves below it and keep the ones above it to minimize water consumption

3、 Preparation of matrix

When cutting, use pure river sand to meet the demand. Pay attention to disinfection before use after preparation to avoid bacteria and insect eggs

4、 Upper pot cutting

When cutting in the basin, first poke a few small holes on the surface of the river sand with chopsticks or wooden sticks, and then put the cuttings in. Don't go too deep into the soil, about three or four centimeters. Also pay attention to the distance between cuttings, about 8 cm. Insert the prepared cuttings in turn

5、 Post insertion management

After cutting, water should be poured in time and covered with a layer of film to moisturize. In the later stage, it should be placed indoors where there is low light, and the temperature should be guaranteed to be about 20 degrees. Wait a week and then increase the light, and often spray water, so it won't take long to take root