Make funnel

As shown in the figure below, cut off the top of the plastic bottle and trim the cut with scissors. After that, it is a self-made free funnel! The soy sauce bottle on the right has two outlets, which is more convenient to use

Make a ladle

Cut off the bottle body and stick an abandoned needle cylinder, which is a simple water ladle, and it is also a water ladle that will not rust. Of course, if you don't have a syringe at home, you can replace it with something with a long handle~

Make a ladle with a long handle

Put the metal handle of the waste window cleaner or the metal handle of the mop that can be retracted and turned on the plastic water ladle, which is a long handle water ladle, which is more convenient and labor-saving

Make a flower shovel

Cut off the bottom of the discarded beverage bottle, trim the edge into an arc, and then put a piece of discarded plastic pipe on the bottle mouth (easy to hold), which is a flower shovel used to shovel soil. After using for a period of time, the shovel head is no longer smooth and can be cut off

Filter

Tie a knot on the net cover of the waste wine bottle, and pull one end of the knot out of the funnel outlet, which is the place marked with red line in the figure below. The upper part is fixed, which is a filter to filter environmental protection enzymes with half the effort

Drain cover

Take a section of a beverage bottle, regardless of its length. Drill some small holes with an electric soldering iron (or fire chopsticks), which is a simple drainage cover. When planting flowers, buckle it on the water outlet of the flowerpot, and then fill it

In this way, a ventilated place is separated at the bottom of the flowerpot, and the excess water can seep out from the small hole seed, which can effectively prevent the basin soil from ponding

Make flowerpots

Cleaning

Clean up the discarded beverage bottles. Be sure to clean them very clean. If you don't clean them up, the sweetness in the beverage will attract small insects~

Cut open

First draw a line in the middle of the beverage bottle to determine the position to be cut, and then cut along the drawn line. Make a small hole in the middle of the bottle cap and nail it with a nail. There is no technical content

Threading

Thread the bottle cap with cotton rope and tie several knots inside the bottle cap to ensure that it cannot be pulled off from the other end of the bottle cap

Screw it up

Twist the cap and put it on the other half of the beverage bottle

Planting

Fill a small amount of water in the beverage bottle to see if it can flow slowly and naturally. Add soil in the beverage bottle, plant potted plants and water through. Later, when the soil is dry, it will automatically absorb water from below. Just observe that there is water in the beverage bottle below. It is very convenient to add water when it is dry

Do you still have plastic bottles at home

Don't throw it away in the future< span>