First step

Prepare tools and knives. Of course, knives must be fast. Hurry to find out if there is a suitable one in your house. It's not the following. Similar ones can also be used, but they should be sharp. (pay attention to safety when cutting ~)

Step two

Choose a good Narcissus seed ball. The ball is full and elastic when pinched. The sphere is flat and oval, which is a good product. The ball has neat edges and feet and is large. It is a good product

Step 3

The Narcissus bought back should first go to the net bag, then remove the soil wrapped on it, and then remove the old skin outside

Clean up the Narcissus ~ ▼

Step 4

Next is the carving of Narcissus. Why do Narcissus need carving? Because after carving Narcissus, it is not only beautiful, but also can make Narcissus bloom more beautiful~

Start from the foot on one side. The red line in the figure below is the place of cutting, and the number is the order of cutting

The finished product ~ is the figure below ~ ▼

Step 5

Then cut the back, cut between the flower bud and the flower bud, and cut it gently! Gently open! Gently open! Important things are to be repeated for 3 times! The red vertical line is still the place of the knife~

After cutting, it is like the following figure ~ ▼

Step 6

Fine carving, remove some of the skin between each bud and carve from the inside to the outside, but remember, you can't carve the bud bad! It's better to bother a little and carve a little than cut it all at once

Finished products after cutting ~ ▼

Step 7

Soak in water for three days, soak the remaining pulp juice, and then clean it. You can put it in a basin ~ then wait quietly for the narcissus to bloom~

Does it look very simple~

The place of the knife is marked~

If it's bad again, it shouldn't be ~