Seed propagation of Begonia sessile

Sowing and breeding usually begin in late October. After seed collection, the seeds shall be stored in wet sand for two to three months. Before sowing, the trench shall be turned over in advance, and then the trench shall be excavated according to the terrain. After sowing, the soil shall be covered, leveled and compacted. And control the watering amount and weed regularly

Cutting propagation of Begonia

If the cutting propagation method is adopted, it can be carried out in spring, summer and autumn. The main step is to select the branches with good growth (1-2 years old) and cut them into cuttings (2-3cm long), and leave about 2-3 sections for each cuttings. Generally speaking, the cutting of stem attached Begonia can be carried out in a large area, especially in spring. After the cuttings are taken, a ditch (2-3cm deep) shall be opened on the whole seedbed, and then the cuttings shall be obliquely inserted into the ditch before filling and compaction. After watering the grass. During the growth of cuttings, the soil must be kept moist. After the cuttings grow new leaves and roots, the grass cover can be removed

Stick stem Begonia strip propagation

The breeding time is generally spring and autumn, that is, the middle of March and the middle of September. The main steps are as follows: first dig pits around the old tree, then bend and press the branches growing at the root of the old tree into it, bury the middle part of the branches in the soil and leave the tree quietly outside. It should be noted that in order to promote its growth, you can cut a hole in the branch near the base and cut the branch after the branch under the soil takes root

Ramet propagation of Begonia sessile

Generally, ramet propagation is carried out in spring and summer. The method is to dig out the mother plant, divide each plant, ensure that each plant has a stem, and then cultivate, water and place it in the shade for breeding. This method is easy to survive