High altitude strip pressing method

There are woody plants at home. What makes people tangle is the bare branches. The bare branches need to be cut off, but such long branches are cut off and thrown away. It's a pity. Huahua suggests that you can directly use the method of high-altitude layering to reproduce new plants

Operation steps:

1. Prepare a disposable syringe (20ml), which can be purchased from the drugstore for a few cents to a few yuan. It is not recommended to use the used syringe to prevent bacterial infection

Take a piece of paper towel and fold it in half twice for standby

2. The bare long branches will be girdled, with a width of 0.5-1cm. Note that the branch cambium must be scraped clean, otherwise it will affect rooting

3. Dip a cotton swab with some rooting agent and apply it to the wound, the proportion is 0.1%

4. Wrap the prepared paper towel on the wound. The upper end of the paper towel shall be tied firmly with thin wire, and the lower end shall not be tied too tightly so that the root system can penetrate out. Wrap and tie the paper towel with fresh-keeping film outside. Pay attention to wrap all the paper towels in the fresh-keeping film. Prick several holes at the bottom of the plastic wrap to drain water

5. Inject water into the paper towel with a syringe, thoroughly wet the paper towel, and replenish water to the paper towel every 1-2 days according to the weather conditions

6. Cover the paper towel with paper to block the light

7. Take root in about a month, cut off the branches, and put them into the basin together with paper towels to slow the seedlings

Decapitation cutting

Flower friends who have raised too many fleshy plants should not be unfamiliar with this. Beheading is one of the ways to promote the explosion of fleshy cubs. However, you can also behead if you have too much meat. There can be too many pots

1. A pot of meat that has grown in vain. For example, the one below looks good from the top, but from the side, it's just in vain

Front

Flank

2. Pull off all the leaves below. Don't have the heart. Even if you keep the leaves, they will wither gradually in the future

3. Cut off the top with sharp scissors

4. Put the small stake in a well ventilated place. Be careful not to direct the sun. Just put it in a bright place. Wait quietly for a period of time, and you can grow buds again

When it was just cut off

After some time

5. And the head we cut off, after drying the wound, we can directly bury it in the soil. Yes, it's that simple

Just cut it off

After the upper basin

6. Don't throw away the pulled leaves. You can directly insert the leaves ~ put the picked leaves in a cool place to dry in the shade, and then put the leaves flat on the soil. Note that the soil should be slightly wet. After a period of time, you can choose to insert the leaves into the soil, or you can choose to separate after the seedlings grow strong

Just cut it off

After some time

(Note: the pictures come from the Internet and the copyright belongs to the original author. Due to restrictions, some pictures cannot be found and the author has not been marked. If your rights and interests are infringed, please contact Huahua wechat qdxixi or qq1273160598 for deletion or copyright payment.)< span>