Preliminary work of cutting propagation of a bunch of red

Selection of cuttings:

For a bunch of red cuttings, healthy branches should be selected from the healthy mother plant as cuttings. The branches should have about two internodes with a length of about 5-10cm

Preparation of matrix:

The best substrate is coarse river sand or vermiculite. If the conditions are limited, sandy soil can also be used

Cutting steps of a bunch of red

1. First remove the leaves at the base of the cuttings, only the upper leaves, and cut them into a 45 ° slope at about 3.5cm with a knife

2. Disinfect the substrate with disinfectant before cutting

3. When cutting, first tie a hole in the matrix with a wooden stick to facilitate the insertion of cuttings. Insert cuttings into about half of the matrix

4. After cutting, water the cuttings and move them to a cool place. After rooting, they can be transplanted into the pot

Attention after cutting a bunch of Red:

Watering should be carried out in time to ensure that the plants are in the shade< span>