Flower raising method

Crystal mud can store water and trace elements and provide nutrients and water for plants

First soak the crystal mud in clean water. Generally, soak it for about 8 hours, and then add water to continue soaking. When soaking, you can add a little nutrient solution. After soaking, take it out and drain it

Take out the flowers from the original basin, remove the soil, wash the roots with water, and then trim the rotten roots. After pruning, it can be soaked and disinfected with potassium permanganate solution

After soaking and draining, it can be transplanted into a new flowerpot with crystal mud. Note that you can put in the plant first to fully extend the root system and fill it with crystal mud. Gently shaking the flowerpot can make the plant in close contact with the crystal mud. Don't plant too deep. Pay attention to ventilation

Precautions

First of all, when raising flowers with crystal mud, don't press the crystal mud hard, just fill it naturally

Secondly, if it is cutting, you can directly cut the branches into the flower pot and water a small amount

note that usually do not need to be watered, you can add a small amount of nutrient solution, can directly spray the plant. If you find that the surface of the crystal mud is too dry or dirty, you can take the crystal mud out of the flowerpot and soak it with clean water. After draining the water, it will be clean again