Method 1: watering

In the process of raising flowers, we can always hear the old gardener say "water and fertilizer management", which shows that watering and fertilization are often coordinated in the process of flower maintenance. If you find that your flowers are fertilized excessively and suffer from fertilizer damage, you can immediately water and remedy the fertilizer damaged flowers continuously. If you water the flowers continuously for 2-3 times, you should be able to dilute the fertilizer with too high concentration in time, so as to discharge high concentration fertilizer

Method 2: replace basin soil

Take out the over fertilized plants from the original basin, clean the roots of flowers after removing the soil, and pay attention not to hurt the roots of plants during the cleaning process. After cleaning, trim the whole plant, cut off the damaged roots and yellow and dry branches and leaves, and dry the wounds to prevent wound infection, and then prepare new basin soil for re breeding

Method 3: timely cleaning

After discovery, the pot soil shall be placed in clean water for cleaning, and the water surface shall be controlled to be about 2-3cm on the surface of the flower pot to ensure that the fertilizer can be cleaned and reduced in time and effectively, and the flowers shall be placed in the shade

Note that the plants that have just changed pots should be placed in a cool and ventilated place as far as possible to avoid direct sunlight, and then carry out normal flower maintenance until the growth of flowers tends to be normal

Flower fertilization method

Fertilization of flowers is mainly carried out according to the growth habits of flowers. It is easy to say for plants that like fertilizer, but for flowers with general fertilizer preference, special care should be taken when applying fertilizer. The fertilization method of this kind of flowers should take "frequent application of thin fertilizer" as the main principle, and apply fertilizer in a timely and appropriate amount

In addition, Xiaobian reminds you that in the process of fertilization, for some delicate flower varieties, we must pay attention to that the fertilizer should not touch the branches, leaves and roots of flowers to prevent burns and seedling burning