Cactus flowerpot made from cans

Author: l-qing

Source: 163 blog

Operation steps:

1. Draw a line on the can according to the height you like. When you can cut it, cut along this line. If it is a small thing like a cactus, you don't need too much soil. You can draw it lower

2. Cut the can with scissors along the line drawn on the can before. When cutting, you must pay attention to your hands and don't get hurt

3. Use scissors to evenly cut the cans into strips with a width of about 7cm, and then use chopsticks to turn out the aluminum pieces of cans one by one to make a beautiful petal shape according to the method shown in the figure below

4. The drain hole is opened at the bottom of the can, which can be done with the grindstone for grinding kitchen knives at home

5. It only takes a few simple steps to make a simple flower pot

6. The small flowerpot made of a pop can is used to raise flowers such as cactus. It's so beautiful

Making a pot with meat in a can

Author: love meat

Source: Sina blog

Operation steps:

1. Find a can, cut off its bottom, and then cut off all the burrs of the incision to make the cutting surface as smooth as possible

2. Use copper wire or iron wire to make a circle that can just cover the periphery of the can

3. Cut the cans about 2cm longitudinally. The number of cuts can be even. It will be more beautiful. Then cover the circle made before

4. Fold each can over the edge of the circle, with the tab facing down

5. After it is completely wrapped, it looks like this as shown in the figure below

6. Find a toothpick, cut off the part with the tip of about 3cm, and roll it up with a can until the edges of all the tilted cans are rolled down

7. Take the bottom of the previously cut can, then let the concave face down and put it on the inner bottom of the can, so that a small flowerpot is ready

8. Add soil into the pot, and then put the plants you want into it.  

Can lid cut cabbage

Operation steps:

1. Cut the cabbage horizontally, cut it into upper and lower parts, and keep the stem of the cabbage

2. Fold the lid of the can in half, then put your finger into the pull ring and cut the stem of Chinese cabbage. Each piece can be cut into several layers

3. Cut off the excess part of the cabbage and pay attention to the cut part. Don't cut it off, otherwise the previous work will be wasted

4. Unfold the cabbage in the water and it becomes a beautiful cabbage flower

Air pineapple flowerpot made of pop can

Operation steps:

1. Prepare two beer cans and a pot of small plants, such as aloe vera

2. Draw an oval with white paper, cut it off, use it as a template, and cut a hole on the side of the can

3. In this way, the edges of the cut cans are relatively sharp. In order to prevent hand pricking, you can trim them in a small range along the edges of the cans, and fold the cutting part inward, so that you won't be afraid of scraping your hands

4. Clean the trimmed cans again, dry them in the air and paint them with a white background, and then draw your favorite pattern or color

5. After painting, the can looks like this in the figure below

6. Put the soil in, and then plant the previously prepared aloe plants into the soil, so as to make a small flower pot of the can. Then hang a rope on the top of the can, and you can hang it anywhere