Ramet propagation

Choose a vigorous plant among many Dendrobium candidum. After it blooms, take it out of the pot and cut it from the base of the stem. Pay attention to take out the old rhizome and minimize the damage to the root system. The root can be directly broken by hand without cutting with a knife. Take the main plant as a group and cut off the old roots around it. How can new plants be formed? Put the new buds in the middle of the spray and constantly fill in the new matrix

Split bud propagation

This situation is applicable to Dendrobium candidum that has been planted or potted for more than 3 years. This method can also be used if some Dendrobium candidum have small plants at the top of the stem. How should small plants be selected? It is best to have three or four leaves and two to three roots. After cutting it off from the mother plant, pay attention to the treatment of the wound. Just smear it with plant ash. When planting plants into pots, pay attention to shallow planting

Cutting propagation

This breeding method can be carried out together with pot change and ramet. Because the rhizome of Dendrobium candidum is thin and long, new buds can grow on each section of the stem. Therefore, this method is more appropriate. When choosing branches, you should choose the branches that have not bloomed and cut them into several sections according to the method of two or three sections per section. Pay attention to the same treatment as bud propagation. Insert the stem into the substrate. The substrate is best made of moss and peat. Do not completely insert it into the soil, but keep half in the air. No watering is needed within a week after cuttage, but be careful to moisturize and spray. After one to two months, new buds will grow, and beautiful flowers will bloom in 2 to 3 years