Infusion

1. Preparation: 1 plastic bottle, 1 infusion set (available in pharmacies or used), 1 disposable cup and straw< span> 

2. Cut the straw into a small section, insert it into the soil, and use the straw, mainly for fear that the soil will block the pinhole< span> 

3. Fill the plastic bottle with water and open a small hole on the cover. The size refers to the plastic needle of the infusion set

4. Put the plastic needle of the infusion set through the paper cup, and then insert it into the cover of the plastic bottle. The paper cup mainly plays a fixed role. If there is a place where plastic bottles can be lifted, they can be lifted directly~

(author: Wei Lan) source: I love vegetable garden)

5, put the needle on the bottom into the straw of the flowerpot, then adjust the speed of infusion, ~

(author: Wei Lan) source: I love vegetable garden)

(author: Wei Lan) source: I love vegetable garden)

PS: in fact, you can also use a full set of infusion facilities~

Coarse cloth strip

Put a cup a part higher than the flowerpot, then dip one end into the water and put the other end in the flowerpot with a thin cloth strip
if you like wet flowers very much, you can wrap cloth strips around the plants in the flowerpot. Be careful not to fold them together~

Example 1

▼

(author: Zhang Hui, source: Zhihu)

Example 2

▼

Mineral water bottle

1. Preparation tools: two straws, a plastic bottle, a pair of scissors and a bottle of 502 glue

2. Make two holes at the bottom of the plastic bottle, with a spacing of about 1cm. While drilling again, pay attention to stick the straw on it

3. Stick the two straws together with adhesive tape

4. Lift the bottle into the soil and insert it into the plastic tube. Note that the yellow tube can only reach the soil surface, while the orange tube should be inserted into the soil~

5. Note that this method is suitable for plants that like moisture very much, such as green pineapple, copper coin grass and so on

6. The device can also have another operation method, that is, the straw is not directly inserted into the soil, but into the tray. The yellow tube is just close to the water surface, while the orange tube is below the water surface

Mineral water bottle

1. Prepare a relatively large mineral water bottle, and then punch several small holes in the upper part of about 3.5cm, such as the following figure. After punching, cut the bottle in half. Note that the bottom half should be smaller in height

2. Turn the top half upside down, fill it with soil, and pay attention to burying 2 lines at the mouth of the bottle

3. Fill the bottle at the bottom with water, subject to the opening just below the top of the bottle, and then you don't have to water it every day

Plastic bag

1. Fill an impermeable plastic bag with water and tie the mouth tightly

2. Use a needle to pierce a very small hole in the plastic bag, and then stick the place where the hole is located on the soil

3. Water will seep into the soil bit by bit along the small hole~

Basin sitting method

This method is the simplest. Find a washbasin, fill it with water, and then put the flowerpot in. Note that the water level cannot exceed the flowerpot

(author: arithmetic problem 1) source: Clivia bar)

Wine bottle pouring legislation

Punch a hole in the stopper of the wine bottle, then fill the wine bottle with water and buckle it into the flowerpot~