Ramet

1. Choose an asparagus that already has small buds

2. Remove the asparagus from the basin and wash the soil at the root with water

3. Carefully observe the root, there will be some nodes growing separately. Hold them with your hand and break them gently. If you can't break them, it means you have found the wrong place. Don't break them by force. That will hurt the asparagus! Just look again~

4. The asparagus can be divided into several as needed, but it is not recommended to divide it into too many trees, which is not easy to survive. Therefore, Huahua suggests that it can be divided into 2 ~ 3 trees

5. Choose a flowerpot of moderate size. You can put some bricks and ceramsites at the bottom of the flowerpot to avoid ponding

6. Hold the asparagus hair with your hand, put it in the middle of the flowerpot, and then fill the soil. Pay attention to break up the roots when filling the soil, and don't group them together, so that they can survive~

7. Don't fill in too much soil. Basically, it's OK to bury it in the place where the roots and stems grow~

8. Pour water through it, and then put it in a cool and ventilated place for maintenance. After that, see dry and wet when watering~

Sow

1. Select seeds with full grains and prepare the soil for sowing

2. Fill the seedling box with nutritious soil and pour it with water. If you hold it, you can have moisture, but it won't form a mass. If possible, special seedling blocks can also be used

3. Put the seeds into the seedling box one by one, and cover the surface with fine soil a little. Spray the surface of the soil with a spray bottle. p>

4. Put it in a cool and ventilated place and keep it dry. It will germinate in about a week

5. After about 4 weeks and 3 days, many real leaves can grow~

6. In another week or so, when you grow up, you can transplant~

High altitude batten

1. Select the branches that have been lignified

2. Use a knife to peel about 2cm around it and peel the bark clean

3. Prepare 2 plastic bottles and remove the top and tail. And cut it along one side to fit it in

4. Fix the plastic bottle to the branch with wire or other things

5. Put sand, moss and the like into the beverage bottle. Remember to wrap it with plastic cloth and try not to let the water leak down

6. Pour water into the soil inside, and cover the top with a layer of plastic cloth to avoid water evaporation

7. After a few days, I opened the plastic cloth and added water to keep the soil moist. Just wait patiently

8. After rooting, remove the plastic bottle, look at the branches and go directly to the basin~

Horizontal batten

1. Choose a soft and long branch

2. Bend it, press the middle section into the soil, and press a stone on it to avoid bouncing up

3. It will take about a month to take root and remove the stone

4. Cut it off and put it directly into the basin