1. Ramet reproduction

We can cut off the small branches from the base of its roots and stems, and then plant them separately to grow into a relatively independent new plant. This method is particularly simple, and the survival rate is also other high. This method is used in general gardens. When using this method, we must pay attention to the selection of branches and planting. Even if it is easy to survive, we can't be too careless

2. Bud planting

We can also plant with bud planting. Generally, we must be prepared before planting with bud

Hole digging: we generally need to divide the distance between each hole, and then start to dig the hole after setting out. Generally, the size of the hole should be determined according to the size of the bud. When digging the hole, we should separate the topsoil and subsoil

Planting: we should first put some fertilizer in the hole, such as cow dung, and then mix it with the soil evenly, and then sprinkle a layer of topsoil of 5 cm to 8 cm to isolate the root system of the fertilizer root bud. Then place it in the middle of the hole to make its roots distribute naturally and reasonably

Encirclement: generally, the height of encirclement is 20 cm, and then shoot some soil on the periphery, so as to prevent it from leaking

Watering: watering is very important for its survival. At this time, we must water it enough and thoroughly. We can generally use some river water, groundwater and tap water as long as the water is not polluted

Mulching film: there are some buds that are not particularly easy to survive. We can lay a layer of mulching film around them, so as to reduce the evaporation of water on the ground, prevent soil caking, and improve the temperature of the ground, so that it can survive better and produce roots and buds as soon as possible