1. Sowing method

The seeds of Eagle Claw flower are relatively small. For the seeds that are difficult to collect by hand, we can wet one end of the toothpick or rod tool in the water, then collect these small seeds and stick them on the toilet surface of the culture substrate, then cover the substrate about 1 cm above, and then put the flowerpot with seeds into the water with a water depth of about two-thirds of the height of the basin; For larger seeds, seeds can be directly seeded directly into the culture medium by 3x5 cm spacing. After sowing, they will be covered with a layer of substrate. Then spray the sprayer or a small hole sprinkler to soaked the substrate layer, and when the soil in the basin is dry, it will be watered again. When watering, attention should be paid to control the strength to prevent the seeds from washing out of the substrate

2. Cutting method

At the end of spring and the beginning of autumn, the climate conditions are more suitable. At this time, you can choose more delicate new branches for cutting. If you want to reproduce in early spring, you can also use the old branches of previous years for cutting. When cutting, mud carbon soil, river sand and other materials can be used as cutting matrix, and nutritious soil can be prepared if conditions permit. Before cutting, it is best to disinfect the cutting matrix first. Medium and coarse river sand can also be used for cutting after being washed clean. However, river sand in saline alkali areas cannot be used because of its high salinity, and sea sand cannot be used because of its high salt content

3. Strip pressing method

Eagle Claw flower can also be propagated by pressing branches. Select more robust branches, peel off the skin about 15-30 cm down from the top of the branches, and the peeling wound is expected to be about 1 cm wide. Then select a film 10-20 cm long and 5-8 cm wide, put some wet matrix in it, and then wrap the peeled part like a wound. Finally, tie the upper and lower ends of the film with a rope and drum up in the middle. It will take root in about a month. After taking root, cut off the branches and root system together, so as to become a new plant