Choice of time

For this method, it is generally carried out in spring and autumn, and rarely sown in summer and winter

Container selection

The general requirement is good drainage. It's best to have holes at the bottom. There are no other special requirements

Matrix selection

The specific requirements are good drainage and air permeability, and rich nutrients. In view of these requirements, we can choose peat soil or other soil that meets the requirements. In addition, we have to prepare some fine sand for later use

Seed selection and treatment

The principle of choice must be familiar to everyone, that is, to choose those seeds that are full and round without damage and moth. After selecting the seed, we have to carry out necessary treatment on it, because it can effectively improve the probability of budding. We have to carry out the relevant treatment of sprouting, specifically putting it into the refrigerator and other places for refrigeration, about two days. Note that the temperature doesn't need to be too low, about three degrees Celsius

Specific sowing and treatment

Put the selected matrix into the container, about 10 cm. After that, mix the seeds evenly with the fine sand we prepared, and then sprinkle them into the container

Then, adjust some conditions. The first is water. In order to ensure the humidity, we can spray some water on the soil surface. The other is the temperature. It's better to keep it at about 18 to 25 degrees. In addition, the light cannot be too strong. If it is too strong, appropriate shading measures can be taken

Ensure that these factors are in an appropriate state, wait about 25 days, and we can see it sprout