Ramet propagation

Breeding time: after this plant blooms, several buds will grow at the base. When these buds grow to one-third to one-half of the mother plant, we can carry out

Preparation of substrate: considering the nutrient content of the substrate, we can use rotten leaf soil and plain sand as the substrate

Specific method: cut these evil buds from the mother plant, and then remove the leaves at the lower part. Wait until the wounds dry and insert them into the matrix we prepared before. Then it is to ensure the suitability of surrounding conditions. The first is the temperature. It's better to control it at 25 to 28 degrees. Then there is moisture. It's best to keep it moist. In addition, ventilation should be provided. After about ten days to half a month, it can take root

Sowing and propagation

About seeds: if we use this breeding method, we need to use some methods to pollinate when flowering. In addition, its seeds are relatively small, so we need to choose fuller ones as much as possible, so the survival rate will be higher

Selection of substrate: the requirements are not particularly strict, and slightly acidic soil is better

Specific methods; First put the prepared substrate into the container, and then sprinkle the seeds into the substrate. Next, cover it with ground moss or plastic film, which is conducive to moisturizing and heat preservation. Ensure that the temperature is controlled within the range of 25 to 30 degrees, and the seedlings can be observed in about 20 to 25 days. When the seedlings grow to about four centimeters, they can be colonized