Cutting propagation

Time selection: the selection of time is not particularly strict, as long as the temperature is in an appropriate state. However, it should be noted that it is best not to choose summer, because this time is just in its dormant stage. Generally speaking, we can choose from November of each year to April of the following year

Selection of materials: in order to improve the survival rate, we must pay more attention to the selection of materials. We'd better choose the branches that are born in the same year and haven't been lignified, and we should also bring tender tips. Its length should be controlled within six to ten centimeters, not too long or too short

Choice of substrate: we can choose river sand as substrate, but we need to screen it first and disinfect it with boiled water. As for the cutting bed, it has to be disinfected before formal cutting

Formal cutting: cut the branches with pre sterilized scissors, and remove the lower part of the leaves. After treatment, soak it in vitamin B12 solution for a while, about 20 minutes. It doesn't take too long. After that, the branches were inserted into the matrix, and the depth was controlled at about 34 cm. The spacing between each insert can be controlled at about eight centimeters. After they are inserted, water them, and then cover them with some plastic film to keep warm and moisturize them

Other breeding methods

In addition to cutting, this plant can also use a variety of propagation methods such as sowing, branching and layering, but they are not as widely applicable as cutting propagation, so its steps will not be introduced in detail here