1、 Operation method

1. Peel off the bulbs. First of all, peel off a layer of film, soil and dead roots on the bulb of daffodils. This is to remove the dirt and prevent it from rotting

2. Carve flower buds. After that, carry out the "cover opening" treatment, and pay attention that the depth of the knife should not exceed the radius length of the bulb. After that, it will be officially carved. Hold the daffodil head in your left hand, stick the index finger of your right hand to the knife surface, cut it up from about a centimeter on the front bulb plate, and cut off the scales until all the leaf bracts are exposed. Note that when we carve, we must not hurt the pedicel and bud. In addition, if it is more than two flowers, it must be carried out after the flower and leaf bracts are completely exposed

3. Handle blades. In order to make the leaves of Narcissus curly, we need to deal with the leaf buds on both sides of the bud. It's OK to cut up from the bottom of the leaf or from the top to the bottom. Gently cut off a small part of the leaf, about one fifth to two fifths. Note that when cutting from bottom to top, the lower part can be small and the upper part can be large, that is, the upper part can be cut more. Also, we can use our thumb to loosen the leaves on both sides, that is, to separate the leaves from the flower buds, and then cut them gently with a knife

4. Carved scape stem. This is similar to the effect of cutting leaf buds. According to the shape of the knife, be careful not to cut too hard, otherwise it will not grow normally. Specifically, the carving methods include "flower pot", "peacock opening screen" and "flower basket", and each treatment is different

2、 Precautions

1. Be careful when operating. Don't cut too deep and hurt the rhizome

2. Do not cut too many blades when handling blades