Money tree

Cutting steps

1. Take strong leaves from the money tree, pay attention to keep the petiole, and then disinfect with carbendazim

2. Prepare loose and fertile nutrient soil with good drainage and air permeability, put it in the flower pot, and insert the leaves obliquely into the soil

3. Put the flowerpot in a cool and ventilated place for maintenance, and generally take root after 1 ~ 3 months

4. When the leaves take out new buds, start to put them in the pot again. You can appropriately add a little nitrogen fertilizer or compound fertilizer to the soil

5. After survival, it can be cured normally. When watering, pay attention to watering after the soil is completely dry. It is better to be dry than wet; When the temperature rises, spray water on the leaves every day

Hupilan

Cutting steps

1. Select a section of robust and broad leaves of Cymbidium, cut about 5 ~ 7cm, soak them in potassium permanganate solution for disinfection, and then dry them in a cool place for one day

2. Insert the blade obliquely or directly into the loose soil mixed with sand and gravel, the cutting depth is 3 ~ 4cm, and then pour water once

3. Put the flowerpot in the place with astigmatism and ventilation, keep the soil slightly wet, don't water too much, and it can take root in about a month

4. After the new buds grow, transplant them in the basin, put them in the astigmatism place for a week, and then pour a small amount of water along the edge of the basin. Do not accumulate water in the basin, resulting in rotten roots. After the success of the basin, daily maintenance can be done

Longevity flower

Cutting steps

1. Cut the vigorous green leaves on the top of the branches of Changshou flower, keep four leaves and dry them in a cool and ventilated place

2. Mix nutrient soil: coconut brick soil: Perlite in the proportion of 5:3:2

3. Insert the leaves into the flowerpot, pour water once, and then place them in the indoor scattered light for curing

4. Pay attention to water control after germination. Too much water is easy to cause stem rot

Epiphyllum

Cutting steps

1. Cut the old leaves for more than two years, 10 ~ 15cm long, and put them in a cool place to dry. Pay attention to the large wound area, which is easier to take root

2. Insert the blade shallowly or obliquely into the garden soil mixed with sand, and the depth is generally 1 ~ 2cm, as shown in the following figure:

3. After successful cutting, spray a little water every 3 ~ 4 days without frequent watering. Keep the soil semi dry and take root in about a month

3. After rooting for 2 ~ 3 weeks, it can be put into the basin. Pay attention to put a piece of soil around the leaves into the basin, water it after 2 days, and then maintain it daily

Sedum fleshy

Cutting steps

1. Select the succulent plants of Sedum, such as black prince, Huangli and white peony, which have a high success rate

Shake and remove the robust leaves gently. Be sure to keep the growth point of the leaves close to the root, and then put them in the astigmatism to dry

2. Prepare the flowerpot with shallow bottom and wide edge, and prepare the soil according to the proportion of Peat: vermiculite: rice husk ash: Perlite = 1:2:1:1 to keep it slightly wet

3. Directly put the leaves flat in the soil or insert the leaves obliquely into the soil. It doesn't need to be too deep to stabilize, and then put them in the astigmatism

4. Generally, it can take about 10 ~ 15 days to take root. Pay attention not to water before taking root and germination, but spray water into the air to keep it moist; After rooting, pour a small amount of water every week and move the pot after the growth is stable

These flowers

It takes only one leaf to survive

Flower friends, if you are interested, try it quickly

Remember to leave a message and share your achievements~