Large oil drums are buried

1. Drill 5-6 small holes at the bottom of the plastic bucket. Don't be too big. Just drill through. Huahua uses a small electric drill here. You can also use scissors and other tools. Pay attention to safety~

2. Dig a hole near the flowers. Be careful not to get too close to it, which is easy to hurt the root system. Put the plastic bucket in the pit. The depth of the pit should be consistent with the height of the plastic bucket

3. Bury the oil bucket and pour water into it from the mouth of the bottle, so that it can automatically supply water to the root of the flower. You don't have to take care of it for ten days and a half months~

The above method may be more suitable for planting flowers. What are the good unmanned watering methods for our potted flowers? Let's have a look~

Oil drums are made into flower pots for storing water

1. Clean the oil barrels used up at home. Huahua has a very convenient cleaning method: find two sheets of toilet paper and pour detergent

Put toilet paper into the oil bucket and add water~

Shake it hard for half a minute. Just rinse it with water twice, so you can wash it at one time without effort

2. The cleaned oil bucket is ready to be cut into two parts, and 1-3 holes are poked on the oil bucket cover

3. Screw the oil barrel cover, put soil on the upper half, and then put it on the lower half of the oil barrel

4. Plant flowers. If you need to go far, you can pour water in the lower half of the oil bucket. When the flowers are thirsty and the soil is dry, they will automatically absorb water from below~

Worried flower friends can also wear a shoelace on the oil bucket cover, so that the water conductivity is better

Even if you don't go out, the flowers in your family who like drinking water can be raised in this way. You don't have to worry about watering~

The vegetables raised in the flower pot with water stored in oil bucket are also very prosperous. Although they look not beautiful, they don't dislike it at all as a "flower fan" who raises more and more flowers

Plastic bottle as hanging bottle

Flower friends who go out for 1-2 weeks can make a small hanging bottle with a mineral water bottle. They only need to tie 2 or 3 small holes at the bottom of the bottle and hang it above the flowers. Huahua reminds you that you'd better put a big pot holder under the pot. Even if you don't drop it, it will drop into the pot holder~

The talented flower friend made a swing bottle directly for the flowers at home. It looks good, too. No matter how ugly the flowers are, they can't die

If it's not good to hang it up, put it next to the flowerpot and wear a shoe to guide the water

At this time, please note that the water level of the plastic bottle must be higher than that of the flowerpot in order to guide the water down. The lower shoelaces only need to be placed on the soil surface of the flowerpot~

Insert a water storage "needle" in the flowerpot

1. Poke a hole in the cap of the mineral water bottle. Don't poke it too big. It's OK to drip water

2. Tie two chopsticks to the mineral water bottle with adhesive tape:

3. Twist the bottle cap open, fill it with water, then tighten the bottle cap and insert it upside down at the edge of the flowerpot. Be careful not to insert it into the root of the flower. Such a water storage needle is ready

Of course, you can also use more suitable things in your house, such as plastic straws~

These methods

Have you learned everything

Put it away quickly~

In case you go out one day, you'll need it