Automatic watering flower box

1, prepare two foam boxes of the same size, which are used as clay boxes and storage tanks, as well as burnt honeycomb briquette and two diameter PVC pipes. p>

2, cut the diameter of the PVC pipe to 5-7 mm shorter than the foam box, then put it upright in the center of the storage tank. Under the pipe, there are 4 5 mm thick tiles. The total height of the pipe can not exceed the height of the inner diameter of the storage tank. p>

3. Smash the honeycomb briquette, then put it into a large pipe and pour 5-10cm thick water into the water storage tank

4. Align and press the soil box on the water storage tank, and then press it hard to make the big pipe leave an impression on the bottom of the soil box. Dig a hole in the bottom of the soil box along the inside of the impression

5. Dig a small hole on the corner of the soil box, the diameter of which is smaller than the small PVC pipe, and put the small pipe on the small hole. The small hole is used to observe the water level of the water storage tank and can also be used to add water and fertilizer

6. After the two boxes are handled, put the soil box on the water storage tank and fill it with soil. You will find that the water is slowly sucked up. Friends who are often away from home can try this method to conserve flowers and plants or grow vegetables

Composting box

1. Cut all the kitchen waste or picked up leaves into pieces, and finally mix them with a little soil

2. If you have pets at home, you can put a little pet feces, not too much, which is conducive to accelerating decomposition

3. After finishing, if you feel very dry, pour some water. Finally, cover it with a layer of soil, which can isolate insects and odor

4. When the humidity is high in summer, we must ensure that the composting box is relatively dry. It is best to put the box in a well ventilated place. In summer, about a month's time, the fertilizer is piled up, which is nutritious and does not attract insects

Cutting

1, prepare foam boards, scissors, tapes and mineral water bottles for cuttings. p>

2. Take Gardenia as an example, cut several fresh and strong branches, and keep at least 1-2 bud points on each branch

3, cut the foam board into a circle, put a few holes on it, and put the Gardenia garnet in. p>

4, scissors cut from the 1/3 of the mineral water bottle, do not cut, pour half the water, put gardenia and foam board into a mineral water bottle, and put a few holes on the bottle cap to tighten. p>

5. Gardenia can take root in about 10 days

Pest control

1, cut the foam board into a circle, and the diameter is smaller than that of the flowerpot. Cut out a hole on the circular plate. p>

2, round the foam board through the main stem of the pot, and put it on the pot that needs insecticide. p>

3. Put an inverted washbasin or small stool on the ground and put the flowerpot flat on it

4. Turn on the tap and scrub the leaves with insects by hand. Before long, the insects on the leaves were cleaned

5. After cleaning, put the flowers in a ventilated place to dry, and then maintain them normally

have you learned how to grow flowers in these foam boxes? p>

do you know what kinds of flowers are used in foam boxes? p>

Welcome to share with Huahua~