Green pineapple cuttings like this, 100% survival

1. Use scissors to cut off the thick and fresh green Luoteng. The scissors had better be disinfected with a lighter in advance

2. Cut the branches of green pineapple into several small sections, each section contains 2 sections, with a leaf and a bud in the middle

3. Prepare rotten leaf soil, peat soil and perlite, and mix them evenly according to the ratio of 2:2:1. It is best to disinfect them in advance, and put them in the sun for a day without disinfection. Then spray water to make the soil slightly moist, and you can plant green pineapple

4. Put the green rose vine in a circle and insert it into the soil vertically, with the leaf face up

5. After cutting, spray some water and put it in a ventilated and cool place. When the soil surface is dry, pour water again, and small buds will grow soon

Longevity flower cutting like this, 1 pot becomes 10 pots

1. Don't throw away the branches of Changshou flower that are usually trimmed down. Cut them with clean ones and cut them into several small sections, and then put them in a cool and ventilated place to dry the wound

2. Prepare clean rotten leaf soil, mix some perlite and spray water to make the soil slightly moist and a little moist. If there is no rotten leaf soil at home, it is OK to mix some river sand with clean garden soil

3. Insert the lower end of the long-lived flower branch into the soil, water it while flooding, and put it on the East-West balcony or East-West windowsill with astigmatism

4. In less than ten days and a half months, the long-lived branches cut can grow a lot of white roots

5. After rooting, bask more in the sun, water once a week or so, and water potassium dihydrogen phosphate once a month. After a few months, it will bloom

Hydroponic cutting of Cymbidium leaves, rooting for 1 week

1. Break off the strong and thick leaves, cut the leaves into several small sections, each of which is about 10cm. After cutting, put them in a ventilated and cool place to dry for 2 days

2. If you see the incision of hupilan, it is a little shrinking and wilting, it means that it is well dried. If it is slightly dried, it will take root faster and have a higher survival rate than that without drying

3. Find a water cup, fill it with water, and put the cut pieces of hupilan into it for 3-5cm. Be careful not to confuse the top and bottom, otherwise it won't take root

4. Insist on changing the water once in about 4 days. You can add a little carbendazim in the water, so that the roots can grow in 2 weeks

5. After rooting, add some nutrient solution or aspirin to the water, and you can grow small buds in about 2 months

Sponge + wet towel, osmanthus cutting 100% live

1. Prepare a cleaning sponge for washing dishes, cut it into small pieces and drill several holes in each piece

2. Cut the semi lignified branches of Osmanthus fragrans, about 10-15 cm long, keep 2-3 leaves at the upper end, and cut obliquely at the lower end

3. Put the branches into potassium permanganate solution, soak for 5-10 minutes and disinfect. Insert the branches into the cleaning sponge

4. Then wrap the sponge with a wet paper towel soaked in water

5. Put the sponge wrapped with wet paper towel into a plastic bottle and pour 1-2cm of water into the bottom

6. Put the plastic bottle on the lid, leave a gap, and then put it on the indoor Nanyang terrace, South windowsill, east-west balcony, east-west windowsill and other places

7. Sponges and wet paper towels can maintain high humidity. Osmanthus can take root in less than a month

Gardenia pinch a branch, throw it into the water and live

1. Cut the healthy Gardenia branches born for half a year, and cut off the lower branches, leaving only the top two leaves

2. The foam boxes that are not used at home can be washed and tied with small holes. p>

3. One branch per hole. Insert the Gardenia branches into the small holes one by one and float them in a container with water. It is best to cover the upper layer with a plastic bag for moisturizing

4. In about ten days and a half months, gardenia branches can grow small white roots

5. After rooting, you can gradually bask in the sun, and then transplant the branches in a separate pot for maintenance in 1-2 weeks

Triangle plum inserted like this, big white root rubbed and risked

1. For cutting triangular plum, you can use coconut brick, disinfect it with carbendazim in water for 30-40 minutes in advance, pinch it slightly after soaking, and pour it into a disposable cup

2. Cut the boughs of Prunus deltoides into about palm length, remove the lower leaves, and leave only 2 pairs of left and right leaves at the upper end

3. Insert the branches of trigonometry plum into the coconut brick soil, then put them into the transparent storage box, spray water on the box wall of the storage box, and then cover the cover, do not cover it tightly, and leave some gaps

4. Put the storage box in a cool and ventilated place, open the cover twice a day, spray water to moisturize, keep water on the box wall, and take root in about 20 days

Camellia inserted like this, one inserted to save life

1. Select healthy and strong Camellia branches that grow for about half a year. These branches are most likely to survive with active tissue and full axillary buds

2. Trim the camellia cuttings so that each cuttings contains 2 leaves, soak them in carbendazim solution for 15-20 minutes, and then take them out to dry

3. Prepare clean river sand and disinfect it with potassium permanganate solution in advance, which can reduce black rods and improve the survival rate

Put the disinfected river sand into the flower pot, spray it with clean water, and poke holes on the soil surface with your fingers

4. Insert the camellia branch into the hole, compact it slightly, cover it with a layer of film, and put it in a place with astigmatism and ventilation for maintenance. Turn on the water spray 1-2 times a day and soon take root

Cuckoos can be inserted like this. How many can be inserted and how many can live

1. Use scissors to cut off healthy and disease-free Rhododendron branches, not too long about 5-10 cm. After cutting, soak carbendazim for disinfection

2. Prepare a mineral water bottle, cut it from the middle, leave a little connection, don't cut it completely

3. Poke several permeable holes at the bottom of the plastic bottle with an awl, and then put the clean perlite into the lower half of the plastic bottle, squat into the container containing water, soak in the basin, or pour it through

4. Insert the Rhododendron branches soaked with a lot of fungicide into the wet perlite, and then put them into the tray

5. Glue the upper and lower parts of the plastic bottle with adhesive tape, pour water into the tray, and ensure that there is always water in the tray during Rooting

6. Put the whole cutting device in a place with astigmatism and ventilation. In 1-2 months, the Rhododendron can grow roots ~