1、 Soil preparation

During cutting, the matrix is generally prepared with peat, perlite and vermiculite in the proportion of 4:1:1. After preparation, it is put into the flower pot and watered once

2、 Cut branches

Generally speaking, pinch 10 to 12 cm directly from the top to the bottom, and then cut off both sides with scissors. Cut off all the leaves at the bottom, and leave 1-2 leaves at the top. Be careful to use scissors. It's best not to use your hands to avoid infection

3、 Insert matrix

Cutting is carried out after cutting. The cutting time is generally between June and September. The temperature during this period is high, which is conducive to rooting. When cutting, one-third of the depth of cutting seedlings is inserted in summer and two-thirds in spring. The temperature is high in summer and easy to rot. in spring, the temperature is low and the humidity is low, so it should be inserted deeper

4、 Later maintenance

Spray water in time after insertion and cover with plastic bags. If the conditions are good, make a seedbed, apply a film on it and pay attention to moisturizing. It's best to control the temperature at 20-25 degrees and take root in about 20 days